This {back to school} teacher gift was so easy!
I shared it over on Lil’ Luna a few weeks ago,
but if you missed it here it is again.
I shared it over on Lil’ Luna a few weeks ago,
but if you missed it here it is again.
To make this I ordered a kit
from Finger Snapper {a new daily deal craft site}
or you could easily make your own.
The wood block measures 8 x 1 x 3.5 inches
and the sheet metal measures 8 x 7 inches.
The wood block measures 8 x 1 x 3.5 inches
and the sheet metal measures 8 x 7 inches.
A slit is cut into the wood block about a 1/2 inch deep.
You just slide your sheet metal into that groove,
& it makes a super cute magnet board.
You just slide your sheet metal into that groove,
& it makes a super cute magnet board.
To dress up my sheet metal a little I grabbed a piece of back to school scrapbook paper.
I traced my sheet metal on the back & then cut it out just smaller than my lines.
After I finished cutting the paper to the right size,
I used Elmer’s spray adhesive to glue the paper to the sheet metal.
I painted my wood block a matching color & then waited for it to dry.
I added some vinyl lettering in the smiley monster font.
Then I just slid the sheet metal into the slot.
I put on a few magnets. That’s it.
I really think it turned out cute!
I think her teacher will LOVE it!
Thank you so much stopping by my blog!
If this is your first time visiting I’d love to keep in touch.
If this is your first time visiting I’d love to keep in touch.
